Discovery Type II Phaser

Laser Cut and engraved acrylic display stand for the Type II phaser from the Star Trek Discovery series. 

Base is made from 1/4" thick clear acrylic ,laser engraved with the Discovery logo and new Star Fleet emblem . 

Supports are made from 1/8 & 1/4" clear acrylic. 

This stand was designed using a 3D printed copy I bought from tinker-labs on ebay. 

To help decide if this will fir yours check these measurements with your phaser, measuring at the points where the supports are. 

Small support for handle is 20mm wide (raises handle up 4mm from base) 

Cradle on main support is 30mm wide 

main support from base to bottom of cradle is 97mm 

Assembly required,no hardware or tools needed.
Occasionally some parts may fit into the base slightly loose. This is due to the acrylic not always being exactly the same thickness, it can be .5 mm different. You may use super glue on the parts tab that inserts into the base. If you do so, please use only  a very small amount,this will tighten the part, your not actually trying to glue it. Or you may use clear tape. 

Phaser is not included